These instructions are for VirtualBox 4.1.18 running on Windows 7 with Service Pack 1 with Ubuntu 12.04 (running the Unity Interface) as the guest OS.

I believe the instructions are the same (or very similar) regardless of which host OS and guest OS combination you are running, but I make no guarantee.

Sometimes you want to (or need to) directly access a USB device, like a memory stick, or a printer, or camera.

Normally, VirtualBox does not provide access to these devices, however, it is possible to allow the guest OS to directly access the USB device.

(I needed to allow Linux to directly access a SD card so I could use the dd command to copy a OS image. This turned out to be very slow. I am not sure if this was because I was accessing it via VirtualBox or because dd is inherently slow writing to flash cards.)

Installing the VirtualBox Extension Pack

1) Go to the VirtualBox Downloads page. It can be found here.

2) Click on the All Platforms link beside the VM VirtualBox Extensions Pack:

3) Click on Open if you get the following confirmation request in Windows 7:

4) Click on Install:

5) Read the license agreement (or, at the very least, scroll all the way to the end) and the click on I Agree if you accept the licensing terms (if you don’t agree, then you will not be able to install the extensions):

VirtualBox will then proceed to install the extensions pack. This will take a few minutes.

6) Observe that the installation was successful and click on OK:

Enabling a USB Device in VirtualBox

1) Plug in the USB device you want to share. Let it be detected and recognized by Windows.

2) Start VirtualBox.

3) Right-click on the virtual machine you wish to configure the USB device for, then select (left-click) Settings…. You could also left-click on the virtual machine and then press Ctrl+S:

4) Click on USB in the left side panel:

5) Check the checkbox Enable USB 2.0 (EHCI) Controller:

6) Click on the tiny USB icon with the green plus sign (it is found on the right side of the dialog):

A menu containing the plugged in USB devices will appear:

7) Click on the USB device you want (this might be tricky because the displayed name may not be obvious – for example, the Unknown device is a webcam):

This will add the device to the list of USB devices available to the virtual machine (again, your list will likely be different):

The first time you start the virtual machine with newly attached USB device, VirtualBox will: (1) disconnect the device from your machine and (2) create a VirtualBox USB device to connect to the device (for which Windows will automatically install the necessary device driver). When this is done, you should get the following notification:

When you log into your guest OS, the USB device will be attached to it.

In the image above you can see several attached drive locations. These are the slots in a card reader I had attached to the computer.

You can also see that the memory card in question was mounted as sdb

If you have attached a different USB device (printer, scanner, camera, etc), the guest OS (in this case Linux) may have limited or no support for the device.

The post VirtualBox – How to Access USB Devices appeared first on Complete, Concrete, Concise.